Jasper Posted April 25, 2016 Share Posted April 25, 2016 Hello guys, I'm using my NANO for a while now and everything worked fine. However, since today Recon isn't working properly anymore. When I scan the area using Recon, I can only scan with 'AP Only'. When I scan 'AP & Client' it's stuck at 100%, no AP's and clients are showed. I've used many options, like 15 seconds, 30 seconds, 1 minute and so on. Continuous scanning doesn't work too. I've got no modules are running, PineAP is switched off and no clients are connected. What's wrong here? Quote Link to comment Share on other sites More sharing options...
Skinny Posted April 25, 2016 Share Posted April 25, 2016 This is a known issue that should be corrected with the next firmware update. This generally happens to me when there is no client or AP to be detected in an area, but others have had other reasons. 1 Quote Link to comment Share on other sites More sharing options...
Jasper Posted April 25, 2016 Author Share Posted April 25, 2016 This is a known issue that should be corrected with the next firmware update. This generally happens to me when there is no client or AP to be detected in an area, but others have had other reasons. Thank you. Hopefully the new firmware update will be released soon! Quote Link to comment Share on other sites More sharing options...
ZaraByte Posted April 25, 2016 Share Posted April 25, 2016 Uhhh I just wanna mention I had an issue with this and it was because the wireless radio was being used by something else but I could be wrong. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.