Jump to content

pineapple mark V stuck at solid green light


mandm

Recommended Posts

I was playing around last night with my pineapple mark V (firmware 2.4.0), when i enabled the PineAP mode i was able to see all the SSID as desired but my device could not connect to internet as i didn't have an external usb wifi adapter inserted in my pineapple.

So in the next round i inserted an external usb wifi adapter and could see it as wlan2 so now i had 2 network connections on my pineapple wal0 wlan1 wlan2

When i tried to configure wlan2 to my home network i kept getting a warning

"warning: channel conflict between wifi pineapple and selected network"

So i changed the channel on the wlan2 and the warning still didn't go away. so i went ahead and hit ok, and then my pineapple got stuck at solid green and i can't even see the access point or when i connect it to my home router via ethernet, i can't even see it connected and active.

How can i get out of this situation?

Link to comment
Share on other sites

I had to reset the Pine when I had this happen last week.

You can use the DIP switches to perform a factory reset but it sounds like you may be using the wrong switches or not using the correct procedure. Try this:

NOTE: With the switches facing you, they are ordered 1 - 5 from left to right.

1) Power off your Pineapple.

2) Place your DIP switches in the following sequence:

Switch 1 - UP

Switch 2 - DOWN

Switch 3 - DOWN

Switch 4 - UP

Switch 5 - UP

3) Power on your Pineapple

4) Wait 5 minutes just to be safe and power off again

5) Place all of your switches back in the up position again and power on.

You should be good to go. Just connect via ethernet or Wifi, login to the web interface, and create a new password.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...