Jump to content

GPS woes. /dev/ttyUSB# does not get created


Go to solution Solved by Sebkinne,

Recommended Posts

When I connect my Garmin GPS18 USB to Pineapple Mark V (firmware version 2.0.4) It shows up in dmesg:

usb 1-1.2: USB disconnect, device number 4
usb 1-1.2: new full-speed USB device number 6 using ehci-platform
however there is no corresponding new tty device listed in /dev. Only a new USB device under /dev/bus/usb/001/004
I have attempted to install GPSD on the sd card, but was unable to get it to enable at boot, so I removed it & installed in on the Mark V.
I can start gpsd from the command line (with gpsd /dev/bus/usb/001/004), and telnet to localhost:2947 and get the following:
telnet localhost 2947
{"class":"VERSION","release":"3.7","rev":"3.7","proto_major":3,"proto_minor":7}
So I know GPSD is installed & runs, I know my GPS is seen by the system, however I cannot get the two to talk consistently as the USB device number changes between reboots (usually between 4& 5)
Short of a factory reset and trying again, I am not sure where to go from here to get GPS working on the Mark V.
Link to post
Share on other sites

This is the most likely answer. We don't support all GPS devices out of the box.

Best Regards,

Sebkinne

Is there a list for all supported GPS deviced?
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...