Jump to content

PineAP not starting (firmware 2.0.3)


fruitful
 Share

Recommended Posts

hi,

just a quick question: what kind of log files should I check when clicking on "Enable" at PineAP (as well as the "Start Now" inside the PineAP tab in the detail tab) just won't start PineAP? I did test it even after a fresh reboot as well as even after a second successful re-flash (firmware 2.0.3). It just won't start. Tested in Firefox & Chrome. The request is executed, but after a few seconds it just returns and everything stays "disabled". All other stuff (including Karma) works well... And even dmesg etc. looks good.

any ideas? or is it just too early to try out the new PineAP features presented at defcon?

best,

fruitful

Link to comment
Share on other sites

just a quick update: even after a fresh boot after a fresh firmware re-flash PineAP didn't start... But: when after the fresh re-flash I chose "Reset all wireless settings" in Network tile (Advanced tab) it started... So the trick was to just reset the wireless settings even after a fresh re-flash... so now it works... :smile:

Link to comment
Share on other sites

  • 1 month later...
  • 7 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...