Pineapple not booting rom

[LabRaTT]

I've been having issues getting my pineapple mark III to boot. So finally i hooked it up by the serial port and this is what outputs

RedBoot(tm) bootstrap and debug environment [ROMRAM]
Accton release, version v1.5.1 - built 20:10:40, Aug 19 2008


Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.


Board: ap51
RAM: 0x80000000-0x82000000, [0x8003f640-0x80fe1000] available
FLASH: 0xa8000000 - 0xa87f0000, 128 blocks of 0x00010000 bytes each.
== Executing boot script in 1.000 seconds - enter ^C to abort
^C
RedBoot> fis list
Name              FLASH addr  Mem addr    Length      Entry point
RedBoot           0xA8000000  0xA8000000  0x00030000  0x00000000
rootfs            0xA8030000  0xA8030000  0x006B0000  0x00000000
vmlinux.bin.l7    0xA86E0000  0x80041000  0x00100000  0x80041000
FIS directory     0xA87E0000  0xA87E0000  0x0000F000  0x00000000
RedBoot config    0xA87EF000  0xA87EF000  0x00001000  0x00000000
RedBoot> reset
+.. Resetting.
Found AR8012 PHY ID is 004d:d021 at 1
Ethernet eth0: MAC address 00:c0:ca:32:88:b7
IP: 192.168.0.1/255.255.255.0, Gateway: 0.0.0.0
Default server: 0.0.0.0


RedBoot(tm) bootstrap and debug environment [ROMRAM]
Accton release, version v1.5.1 - built 20:10:40, Aug 19 2008


Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.


Board: ap51
RAM: 0x80000000-0x82000000, [0x8003f640-0x80fe1000] available
FLASH: 0xa8000000 - 0xa87f0000, 128 blocks of 0x00010000 bytes each.
== Executing boot script in 1.000 seconds - enter ^C to abort
RedBoot> fis load -d vmlinux.bin.l7
Image loaded from 0x80041000-0x80291086
RedBoot> exec
Now booting linux kernel:
 Base address 0x80030000 Entry 0x80041000
 Cmdline :
 

[Mr-Protocol]

Try a re-flash using the Mark III method.

[LabRaTT]

do you have a link?

[Mr-Protocol]

To how to flash or the firmware?

Flashing:

Firmware: https://www.dropbox.com/sh/y0an70sofvtezzl/P1rMEo9R4a/Jasager/Mark%20III%20Firmware