PineDominator Posted August 6, 2012 Share Posted August 6, 2012 (edited) not sure if there is a command that could be run at the very start of the pineapple? problem Im having is when I have a usb hub and an alfa NHA connected, at first power up it's all good and visable with iwconfig but if I reboot the pineapple with out ever bringing wlan1 up then after the reboot the wlan1 interface is not there? works fine if I ifconfig wlan1 up and then reboot. Edited August 6, 2012 by petertfm Link to comment Share on other sites More sharing options...
sickduck Posted August 6, 2012 Share Posted August 6, 2012 I have the same problem. I have to pull the power on the pineapple and hub to do a reboot in that situation. Link to comment Share on other sites More sharing options...
PineDominator Posted August 6, 2012 Author Share Posted August 6, 2012 I have the same problem. I have to pull the power on the pineapple and hub to do a reboot in that situation. thank god someone else is experiencing this, I've been trying to iron out the issues with hubs for a long time now. Link to comment Share on other sites More sharing options...
sickduck Posted August 7, 2012 Share Posted August 7, 2012 Maybe it has something to do with the hub still providing power to the USB device. Maybe the host side resets but the device never does. If it makes any difference my USB hub backfeeds power into the pineapple. I never got around to snipping the red wire on the data cable. My company uses a lot of USB UARTs powered only by the USB bus. They are buggy and sometimes loose connection to the computer. Unplugging and replugging the USB cable fixes the problem but it is usually easier to tell them to restart the computer. However I noticed on some computers the USB ports never seem to loose power and the reboot never fixes the problem. So now I tell people to completely power off their computers, wait a few seconds and then power it back on. Link to comment Share on other sites More sharing options...
Neworld Posted August 9, 2012 Share Posted August 9, 2012 Any solutions yet?? Link to comment Share on other sites More sharing options...
Sebkinne Posted September 15, 2012 Share Posted September 15, 2012 Fixed in 2.6.3+. Best Regards, Sebkinne Link to comment Share on other sites More sharing options...
Recommended Posts