Search the Community
Showing results for tags 'wlan1'.
Found 4 results
Another problem all. Trying to set I'm WFP to my local network for internet however in the drop down box it only gives me wlan1 option but the note below states "using wlan1 will interfere with pineap" how can I get more options ??
Hi Again! So I have had the wifi pineapple for a couple of weeks and the results have been mixed. I have not used that much and I can say that it is at least a really good concept. Anyway when I today looked at the module SignalStrength I noticed that wlan0 is so much stronger than wlan1. This concerns me because is not wlan1 used always for the offensive attacks like PineAp and other stuff. I don't know if my pineapple is broken or not but this could be why my results have been very poor. I'm using the same antennas for wlan0 wlan1 As you can see is the differences pretty big. PineAp is disabled and the Pineapple was freshly factory rested. I have not contacted Hakshop but will maybe do in the future. I think it should not behave this way or should it? Very poor performance when running PineAp so I expect not...
Hey guys, I have a bit of a strange issue with my Nano When broadcasting with pine, I noticed that a'lot of the times Wlan1 quits when scanning with recon, showing no aps available and with using the site survey module the interface disappears. This has even happend when I have dead-dropped the Pineapple at a client target location, iv come back days latter to find wlan1 turned off and all the captured ssids to stop broadcasting. This requires a hard reboot (unplug from power and replug) What should I do about this? It is extremely annoying when using in the field at a client location as it ends up throwing a wrench in our attack vector. Haaaaaalp! :)
Hi all, Hoping somebody could help me... I was hoping to use my Tetra to have one radio running PineAP and the other radio connected to the network via WIFI Client Mode. Unfortunately the only option I have under client mode is WLAN1 which is says will impact PineAP. I have confirmed that WLAN0 exists and that I can use it for monitor mode etc. Any ideas? Is what I am wanting to do possible? (I would of thought that was a standard use case). Cheers!!!