Jump to content

mifi

Members
  • Posts

    3
  • Joined

  • Last visited

mifi's Achievements

  1. Ups, forgotten, the problem is that the order of the default gateways is wrong. In first place is br-lan and in second place only eth1. This means that the attempt is made to send the data via br-lan. Regards
  2. Hello, Here I have a mk7 with the latest firmware, v1.1.1. The internet connections should be established by an ASIX AX88179 device which is connected and got an ip address: root@mk7:~# ifconfig eth1 eth1 Link encap:Ethernet HWaddr XX:XX:XX:XX:XX:XX inet addr:192.168.1.70 Bcast:192.168.1.255 Mask:255.255.255.0 inet6 addr: XXXX::XXXX:XXXX:XXX:XXXX/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:281 errors:0 dropped:158 overruns:0 frame:0 TX packets:96 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:20367 (19.8 KiB) TX bytes:8620 (8.4 KiB) But unfortunately the default route is set to the br-lan root@mk7:~# route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface default 172.16.42.42 0.0.0.0 UG 0 0 0 br-lan default wpad.fritz.box 0.0.0.0 UG 210 0 0 eth1 169.254.0.0 * 255.255.0.0 U 202 0 0 eth0 169.254.0.0 * 255.255.0.0 U 206 0 0 br-lan 169.254.0.0 * 255.255.0.0 U 309 0 0 wlan0 172.16.42.0 * 255.255.255.0 U 0 0 0 br-lan 192.168.1.0 * 255.255.255.0 U 210 0 0 eth1 Therefore it is not possible to get an internet connections by the eth1. If I add the route by hand: root@mk7:~# route add default gw 192.168.1.1 eth1 The connection is working. Best regards, Michael
  3. Hello HAK5 Team, I do not own a cable at the moment. I only read some setup instructions and it looks that the cable can use in station or ap mode. It might be a good idea if SSID of the ap can be in hidden mode? Best regards, Michael
×
×
  • Create New...