Jump to content

RIT-V300

Members
  • Content Count

    2
  • Joined

  • Last visited

About RIT-V300

  • Rank
    Newbie
  1. I would like to set up the demonseed to function on a computer without digispark's drivers. Currently it only functions on the PC I used to program it, and is recognized as a digispark device and given those drivers before it will begin to type things. If I plug it into my laptop however, which does not have the drivers, it doesn't do anything. From windows I get an error along the lines of "device descriptor failed" and on my ubuntu partition I get the following errors from "dmesg": [ 534.334807] usb 3-1: new low-speed USB device number 2 using xhci_hcd [ 534.462833] usb 3-1: device descriptor read/64, error -71 [ 534.698827] usb 3-1: device descriptor read/64, error -71 [ 534.934783] usb 3-1: new low-speed USB device number 3 using xhci_hcd [ 535.062829] usb 3-1: device descriptor read/64, error -71 [ 535.298831] usb 3-1: device descriptor read/64, error -71 [ 535.406889] usb usb3-port1: attempt power cycle [ 536.058824] usb 3-1: new low-speed USB device number 4 using xhci_hcd [ 536.059334] usb 3-1: Device not responding to setup address. [ 536.267336] usb 3-1: Device not responding to setup address. [ 536.474829] usb 3-1: device not accepting address 4, error -71 [ 536.602838] usb 3-1: new low-speed USB device number 5 using xhci_hcd [ 536.603349] usb 3-1: Device not responding to setup address. [ 536.811343] usb 3-1: Device not responding to setup address. [ 537.020176] usb 3-1: device not accepting address 5, error -71 [ 537.020291] usb usb3-port1: unable to enumerate USB device I searched around online and I suspect the demonseed is not set up to send a proper HID response, and currently relies on the digispark drivers to tell the OS that it's supposed to be a keyboard. I'm totally new to the entire area of hardware related anything though, so I really have no idea. Am I on the right track here, and if so is there a way I can get the demonseed to properly respond so it's not reliant on the drivers to function?
  2. I had a problem with arduino finding the device after installing micronucleus drivers. If this happens check the device manager and make sure the demonseed's drivers are set to digispark's and change them if they are not, the device should be named "digispark bootloader" if this is done correctly. In my case it was showing up as "micronucleus" and using the micronucleus drivers which meant arduino did not see it.
×
×
  • Create New...