Jump to content

PiAnAnXa

Members
  • Content Count

    3
  • Joined

  • Last visited

About PiAnAnXa

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Although the doc assures the Y-cable should produce enough power, it seems this time it wasn't. With a 12V wall adapter, the TETRA booted up. Thanks
  2. The flash file was "tetra_factory.bin". So I believe this is the factory firmware that you pointed out. I didn't use a wall adapter, but used the Y-cable.
  3. Hi, I've a similar problem, but after I've put the recovery firmware on, I still have the Tetra rebooting (amber led then blinking blue led over and over again). I cannot get an ip from the tetra. I can, however, enter in recovery mode on 192.168.1.1 (my fixed ip192.168.1.2) and go on the update page. Putting the recovery firmware again and all starts over again. Any idea how to unbrick my tetra. Thanks
×
×
  • Create New...