nano_noob

you are right! worked! Thank you so much!

pasting from how-to page " Connect the host PC to the WiFi Pineapple via the USB Ethernet Port NANO: The male USB A plug TETRA: The Micro USB port labeled ETH From the host PC, configure a static IP address on the WiFi Pineapple facing Ethernet interface to 192.168.1.2 with netmask 255.255.255.0 " Ethernet interface facing pineapple. You sure about not needing the eth-usb adapter?

i've tried factory reset but it wont procced, and i cant get to web iface so as i understand i need to follow Firmware Recovery road.... (Connect the host PC to the WiFi Pineapple via the USB Ethernet Port)

Thanks. gonna get usb->eth tomorrow and give it a try!

Hey all, story is, i plugged in nano, went to update, selected new firmware and hit go, then unplugged one of the USB's .... Now nano will power up, go solid blue light for 4 seconds and that's it, after 4 seconds its "dead". Tried the factory reset "To perform a factory reset from a fully booted WiFi Pineapple, hold the RESET button for approximately 7 seconds. The device will then reboot. " but nothing changes. If i press and hold reset after during initial 4 seconds it just stays solid blue but there is no possibility to connect to it etc. any help?