whypineapplewhy

exactly - i did just manage to get further with it - right to the upgrading firmware section - the device then rebooted but remained off with no LED's for longer than 10 minutes - any ideas?

no there was no interruption of the upgrade - i didnt get that far.

tried again with the usba -a plugged into my pc and the y cable connected to the nano - light eventually went solid so i tried to setup via the phone app , got stuck on the step where it asks to turn off the antenna , pressed continue after a fast press of the reset button and then it started disconnecting / reconnecting to the phone.

so i can plug the wifipineapple into my pc holding the reset which results in a solid blue light for 30 seconds or so and then the disconnecting / connecting starts again. same thing happens on the phone.

Hi All, so i began setting up my pineapple , got about halfway through (just got it connected to my phone) and had to stop - unplugged it packed it back up in the box and went home. Tried to do the same thing today and the pineapple never fully boots , just blinking blue LED - if i plug it into the computer / phone its just diconnecting and reconnecting - factory reset and firmware upgrade process seem to do nothing to interupt the blue flashing and the device never properly boots. Have searched but not found anyone with a similar issue help! regards