bsalita

What is your use case?

I sent a request to @Sebkinne for support of Lan Turtle (Realtek) USB-to-Ethernet adapters within Nano firmware. Hopefully this will be included in a future firmware update. Seems like the LAN Turtle should be supported as its the only USB-to-Ethernet adapter sold by Hak5. That said, I went ahead and purchased a ASIX AX88179 chipset based USB-to-Ethernet adapter, a Plugable Technolgies USB3-E1000 for $15. It works OOB with the Nano's 1.1.1 firmware. Be sure to follow the networking setup described by @HercMull above.

I'm seeing that the ASIX AX88772A listed in Windows Device Manger is the Pineapple Nano plugged into the USB port. The Turtle uses a Realtek controller which, when plugged into Windows, is shown in the Device Manager as a Realtek network controller. When plugged into the Pineapple, it is shown as: Bus 001 Device 006: ID 0bda:8152 Realtek Semiconductor Corp. However, the Pineapple's `ifconfig -a` doesn't display its interface.

Windows reports the LAN Turtle as a Realtek USB FE Class Family Controller. An ASIX AX88772A is also mentioned but doesn't disappear when I put out the Turtle.

er, make that a lot of difference in the first line.

Bus 001 Device 006: ID 0bda:8152 Realtek Semiconductor Corp. Bus 001 Device 004: ID 05e3:0745 Genesys Logic, Inc. Bus 001 Device 003: ID 0cf3:9271 Atheros Communications, Inc. AR9271 802.11n Bus 001 Device 002: ID 058f:6254 Alcor Micro Corp. USB Hub Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Same as what you posted accept a bit of difference in the first line.

Newbie here. Using firmware 1.1.1. When I plug in the LAN Turtle into the Nano, dmesg shows: [ 758.300000] usb 1-1.3: new high-speed USB device number 6 using ehci-platform However, ifconfig -a doesn't show eth1 or wan2 or any new interface. I'm guessing the issue is that the LAN Turtle is recognized as a generic USB device but not an Ethernet device? What am I missing? What commands should I use to install or debug?