Jump to content

jk303

Active Members
  • Posts

    7
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

jk303's Achievements

Newbie

Newbie (1/14)

  1. While playing in lab i noticed some of my devices that were set to send out probes were not showing up on SSID list via GUI. 1st day playing with Tetra was wondering if there was more depth vs. GUI to validate/verify findings. Unassigned clients would in most cases be out-of-scope. I can see it being used for targeted 'marketing/stats' perhaps.
  2. Yah did all of that. Strange it started working - reboot. Oh and I guess sharing on mac automatically enables net.inet.ip.forwarding=1 . ok tx!
  3. Did you also add default GW on Tetra to your MAC USB Interface IP and setup ip.forwarding on mac for Tetra to get internet Access via mac? Not having luck with this.
  4. Good call - that is big difference. Tx
  5. Thanks! Hmm... I noticed that airodump via CLI had bit more results that it captured as far as SSID probes than the GUI LOG. In fact - watching it side-by-side right now, and SSIDs popping out in airodump that GUI never registers in either RECON nor in logged probes.
  6. Working ok on OS X 10.11.3 BUT had to reboot (combination of times) before I saw it show up. Installed drivers from realtek; rebooted mac; (had to do this 2x - 2nd time I disconnected Tetra from MAC). Then I noticed USB 10/100 LAN adaptor show up in System Information -> Network. Then I connected Tetra, no DHCP, i rebooted Tetra, boom, got IP. Took few times before I actually saw things working BUT had to reboot/re-connect few times, that did the trick for me.
  7. Those unassociated clients - is there a way to see their probe/beacons of SSIDs they are searching for to connect to within GUI or CLI of Tetra?
×
×
  • Create New...