spac3gh0st

heh yeah i do understand that, it was weird because my ipv4 after sharing connection, from windows to pineapple, the pineapple ipv4 status read 'no connection' while i was most certainly sharing connection? but yes thanks again!

got it working again ! i did firmware recovery and fixed all my issues heh im still curious why on my windows machine the ipv4 read "no internet connection" when i was still able to connect to my pineapple on that adapter? but never the less thank you everyone !

sweet and yes ive seen the video @b0N3z, what happens is, i am able to share and successfully connect i just dont get any clients showing up on the home gui or in Filters and Profiling tabs.. as well as Clients. On my windows machine, same thing. My ipv4 is 172.16.42.42 , i successfully share and connect devices to Pineapple but the status on that adapter general tab reads "no network acess" on ipv4... @Zylla i am able to ssh into my pineapple with putty and thru linux, and i do get to the web page just no clients show when infact i know i have tested connection to the pineapple on multiple devices.... im just stumped thanks comrades!

yeah im having this issue as well, i noticed when i iwconfig with the pineapple (after ive ran the ./wp6.sh and connected ) iwconfig lo no wireless extensions. enx00c0ca8faf62 no wireless extensions. enp3s0 no wireless extensions. wlp2s0 IEEE 802.11bgn ESSID:"WifiLAN" Mode:Managed Frequency:2.462 GHz Access Point: Y0:1D:7d:V2:BE:05 Bit Rate=72.2 Mb/s Tx-Power=20 dBm Retry short limit:7 RTS thr=2347 B Fragment thr:off Encryption key:off Power Management:off Link Quality=70/70 Signal level=-28 dBm Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:7 Missed beacon:0 meow?

greetings! im having a hard time getting clients registered on my nano gui? so far i have wifi and am successfully sharing and connecting to my nano from another laptop and phone.... im just not able to use PineAP and my modules... sadface... ive been able to use my nano before and didnt have any problems with my linux boxes(kali , mint, and ubuntu) or windows machine ( Win10) i factory reseted the bad boy and i still no PineAP use. im coming to a wall here are my Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface default 172.16.42.42 0.0.0.0 UG 0 0 0 br-lan 172.16.42.0 * 255.255.255.0 U 0 0 0 br-lan what could i have done to make this happen ?