sethrbeavers

WPS reaver issues Okay, so here we go again. I have tried this post 4 times now and every time I try to load a photo and it erases all content on the post. So no photos. I see a few people have had the same issue as me but it was never resolved or the resolution was never posted. I boot WPS Enable Wlan1 scan networks disable Wlan1 Enable monitor mode click on the AP I want to target select mon0 and the fun stops. I associate but never send my first pin! It must be his signal strength you say! Well I have two yagi 16dbi antennas. So I plug my ALFA into my computer and run Kali. Same network same computer same location with a worse antenna and I immediately start pin attempts. Any ideas? I had a whole slide show but the bulletin board hates me. Signal strength is 60-70%