I sat and left my mark v on after using. Came back an hour later, put wlan1 in monitor mode and ran airodump. Nothing.
I cannot detect or connect to aps with wlan1. wlan0 works normally.
Getting "phy1: RF Calibration Failed! a66" with dmesg. Any ideas on this? I'm worried this may be hardware failure but admit I don't know enough to really make that diagnosis.
I've tried restoring factory defaults and have tried flashing the latest firmware.
root@Pineapple:~# iwconfig
lo no wireless extensions.
wlan0mon IEEE 802.11bgn Mode:Monitor Tx-Power=18 dBm
RTS thr:off Fragment thr:off
Power Management:off
wlan1 IEEE 802.11bg ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=0 dBm
RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
wlan0-1 IEEE 802.11bgn Mode:Master Tx-Power=18 dBm
RTS thr:off Fragment thr:off
Power Management:off
eth0 no wireless extensions.
br-lan no wireless extensions.
root@Pineapple:~# lsusb
Protocol spec without prior Class and Subclass spec at line 17398
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 002: ID 058f:6254 Alcor Micro Corp. USB Hub
Bus 001 Device 003: ID 0bda:8187 Realtek Semiconductor Corp. RTL8187 Wireless Adapter
Bus 001 Device 004: ID 058f:6366 Alcor Micro Corp. Multi Flash Reader
root@Pineapple:~# lsmod | grep rtl
rtl8187 46576 0
rtl8180 25168 0
mac80211 318192 7 ath9k_htc,rtl8187,ath9k,rtl8180,rt2800lib,rt2x00usb,rt2x00lib
usbcore 99168 20 pl2303,option,rndis_host,usb_wwan,cdc_ether,asix,usb_storage,usbserial,usbnet,cdc_acm,ath9k_htc,uhci_hcd,ohci_hcd,ledtrig_usbdev,ehci_hcd,rt2800usb,rtl8187,rt73usb,rt2x00usb
eeprom_93cx6 1632 2 rtl8187,rtl8180
cfg80211 184064 7 ath9k_htc,rtl8187,ath9k,rtl8180,ath,rt2x00lib,mac80211
compat 9472 9 ath9k_htc,rt2800usb,rtl8187,ath9k,rtl8180,rt73usb,ath9k_common,mac80211,cfg80211
root@Pineapple:~# ifconfig wlan1
wlan1 Link encap:Ethernet HWaddr 00:13:37:97:10:3D
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
root@Pineapple:~# dmesg |grep phy1
[ 14.730000] ieee80211 phy1: Selected rate control algorithm 'minstrel_ht'
[ 14.730000] ieee80211 phy1: hwaddr 00:13:37:97:10:3d, RTL8187vB (default) V1 + rtl8225, rfkill mask 2
[ 14.760000] Registered led device: rtl8187-phy1::radio
[ 14.760000] Registered led device: rtl8187-phy1::tx
[ 14.760000] Registered led device: rtl8187-phy1::rx
[ 38.880000] ieee80211 phy1: RF Calibration Failed! a66
[ 180.000000] ieee80211 phy1: RF Calibration Failed! a66
[ 205.310000] ieee80211 phy1: RF Calibration Failed! a66
[ 648.440000] ieee80211 phy1: RF Calibration Failed! a66
root@Pineapple:~# dmesg |grep phy0
[ 10.690000] ath: phy0: Enable LNA combining
[ 10.710000] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[ 10.710000] Registered led device: ath9k-phy0
[ 10.710000] ieee80211 phy0: Atheros AR9330 Rev:1 mem=0xb8100000, irq=2