nemesis_00

have you copied files in the ducky? (the mediafire link at https://github.com/hak5darren/USB-Rubber-Ducky/wiki/Payload---mrgray%27s-rubber-hacks)

have you already tried one digit at the time with delay?

ok, so that's what i did airmon-zc start wlan2 //ok airodump-ng wlan2mon //all networks are dispalyed wash -i wlan2mon --ignore-fcs //nothing displayed, if I include fcs it's all bad fcs reaver doesn't work but i think because of the router which has the push button function I've tried wash with wlan0 and wlan1 (enabling monitor and disabling interface with airmon-zc) but it still doesn't work, all bad fcs

weird stuff going on... airmon-ng start wlan2 //awus036neh is in monitor mode airodump-ng mon0 //lots of newtwork, even mine :D wash -i mon0 //nothing but bad fcs reaver ... //no results (even trying the right pin) because i discovered that the router has a push button, inside router administration webpage so my main concern (awus036neh doesn't work) is gone last question is: what's wrong with wash? from terminal just doesn't work, from infusion can't see existing networks

I can't change channel or signal, but it seems everything is already right: both 2,4ghz and 5ghz are enabled and working

yes, it's a cisco Linksys EA4500 with wps active When I search for APs it found about 20 non wps APs but not my wifi network...

My wifi is on 802.11n, with pineapple i can't see it beacuse i've read that RTL8187 doesn't support it, so i connected AWUS036NEH, which support 802.11n, and searched for APs with wps infusion with wlan2 (AWUS036NEH) but I can't still find it, what am I doing wrong? (firmware and infusions updated, using power adaptor not battery) Thanks

any news about this problem?