I just purchased two rubber ducky. I am new to this, but have following the youtubes and reading a lot of posts.
Well my first attempt is to create the HELLO WORLD payload, but I am stuck at flashing the device.
I am following the instructions located at : https://github.com/hak5darren/USB-Rubber-Ducky/wiki/Flashing-ducky
My System : Windows 7 64bit
1. I already have the following MS Visual C++ 2010 Red. (x64/x86) installed
2. I installed Flip
3. I had to manually install the Atmel Driver
4. Downloaded firmware duck_v2.hex (i assume this is twin duck) from https://github.co