Hello everyone,
I've gotten through the majority of flashing the ducky using the dfu-programmer, but at the very last command, I don't seem to be getting any outcome. The steps I've taken are as follows:
./configure
make
make install
dfu-programmer at32uc3b1256 dump >dump.bin
dfu-programmer at32uc3b1256 reset
dfu-programmer at32uc3b1256 erase
dfu-programmer at32uc3b1256 flash --surppress-bootloader-mem c_duck_v2.1.hex
The output of the last command that I get is what would be displayed if I only entered "dfu-programmer". That is, I get a list of targets, and an explaination of the commands and syntax for using dfu-programmer.
I haven't tried using a different .hex file yet, but I'm just about to head to work so it will have to wait until later.
This is in Kali, if that's been known to have any issues. And yes, the ducky has been put into DFU mode via the button on insertion.
Does anyone else have any suggestions/see something I may have missed?
Thanks in advance, C