Key

Hey so here is the link to flash the ducky https://github.com/hak5darren/USB-Rubber-Ducky/wiki/Flashing-ducky . If you have any problems you could just reply to this post and I'll help you out. So basically the Twin duck firmware allows you to use the ducky as both a HID and a USB mass storage device. The only limit is that the inject.bin can only be up to 2kb but that isn't much of a problem since you could just put all of the work in an executable on the storage and run it from there.

I looked at the inject.bin size and noticed it was over 2kb. I didn't notice that the twin duck software only allows up to 2kb. Thanks!

Hey so I recently got my USB rubber ducky and flashed it with the Twin Duck firmware. After a day the ducky stopped working. Every time I plug it in the red LED turns on then off. The SD card and ducky work if they are separated though. Does anyone know a solution to this problem?