Jump to content


Active Members
  • Posts

  • Joined

  • Last visited

Recent Profile Visitors

362 profile views

UK_Steve's Achievements


Newbie (1/14)

  1. Thanks Daddyphathax for your reply - I simply re-flashed 2.3.0 over the top of 2.3.0 and now ok.
  2. After flashing to firmware 2.3.0 is anyone else finding that although scanning for AP - APs are displayed following the time period set for the scan, but when scanning for AP & Client the scan does not stop and no APs or Clients are displayed ?
  3. Many thanks for fixing the modeswitch issue.
  4. Unable to offer any assistance as I am no further foward with my dongle, but pleased see I am not the only one experiencing a problem with modeswitching following the recent firmware updates. Like you my dongle works flawlessy under fireware version 1.0.4 - looking forward to an answer to this annoying problem.
  5. As explained in my original post my MF112 3g dongle no longer works with firmware 1.1.0 or 1.1.1, but when using firmware version 1.0.4 the Mobile Broadband Settings that work for me in the UK using a sim card from three.co.uk are as follows:- Interface Name: ppp0 Protocol: 3g Service: umts Device: /dev/ttyUSB2 (if this device does not work try one of others listed after issuing ls -l /dev/ttyUSB*) APN: 3internet Username: leave blank Password: leave blank Default Route: 1 ppp redial: persist Peer DNS: 0 DNS: Keepalive: 1 pppd options: noauth Hope this helps.
  6. I cannot think of a different issue as this is the only 3g dongle that is use with the Mark V. I just know that if I roll the Mark V back to 1.0.4 the modeswitch takes place and issuing ls -l /dev/ttyUSB* results in /dev/ttyUSB0, /dev/ttyUSB1 and /dev/tty/USB2 being detected whereas rolling the Mark V forward to 1.1.0 or 1.1.1 and issuing ls -l /dev/ttyUSB* results in "No such file or directory." I shall continue to compare 1.0.4 with 1.1.1, but any help or advice would be much appreciated.
  7. My ZTE MF112 3g dongle used to work with Firmware Version 1.0.4, but something changed in Firmware Version 1.1.0 which resulted in the modeswitch no longer switching. I had hoped that this would be fixed in Firmware Version 1.1.1, but it has not. Can anyone help ?
  • Create New...