Jump to content

sdguy619

Active Members
  • Posts

    5
  • Joined

  • Last visited

Recent Profile Visitors

414 profile views

sdguy619's Achievements

Newbie

Newbie (1/14)

  1. Yes, set eth0 to a static ip of 192.168.1.2. Also double checked to verify that eth0 did indeed show the correct ip.
  2. I have gone through steps 1-4 but can not get to step 5. The page will not load and I get the lights as I described above.
  3. First thing I did was download the "stager.bin and "upgrade.bin. Then I checked to ensure the MD5 matched, which they did. Then I changed the dip switches to 11110 while it was powered off. I then set my eth0 ip to 192.168.1.2 on my laptop. Turned on the pineapple ensuring that the ethernet was connected to the pineapple and my laptop. Then pretty much right after powering up, the pineapple shows solid green, solid amber, solid blue, and a blinking red.I waited 5 seconds, then 10 then, 5 minutes. The browser just kept timing out. I tried powering off the pineapple setting the dip switches to reset, powering back on. Then powering off and setting it back to 11110 and powering on. I was not able to connect via the browser to the pineapple, it times out. I tried via ssh and could could not connect either. I double checked ifconfig to ensure eth0 was set to the correct ip which it was. From my understanding in order to flash the "stager.bin" it needs to be uploaded via the browser unless I am reading it wrong. Oh I left the microsd card in the pineapple while doing this. just wanted to put more info out here in case it helps. Thanks for the help!
  4. If you mean following these instructions, https://wifipineapple.com/?flashing Yup, tried that... Red light just keeps taunting me!
  5. I was going through the first steps of setting up my pineapple. After plugging in the power, about 30 seconds in the power cable fell out the wall.... Damn old outlets! I have followed the steps on unbricking the MKV but can not connect to it. I get a solid green, amber, blue, and a blinking red. The page just times out. I tried the resting using 10011 then setting it back to 11110 but still can not connect. Powering off and on between each dip change. Any help would be much appreciated!
×
×
  • Create New...