So I'm trying to setup my quadcore 955 black edition running on a M4A79T Deluxe SE board with the built in ethernet, however the latest version of proxmox won't allow me to connect to it after installing to a terabyte hard disk.
I've run IFCONFIG and this is what the screen displays:
Link encap: Ethernet HWaddr 00:24:8c:6e:bd:c0 inet6 addr fe80:224:8cff:fe6e:bdc0/64 Scope: Link UP BROADCAST RUNNING MULTICAST MTU: 1500 Metric:1 RX Packets: 0 errors: 0 dropped: 0 overruns: 0 frame:0 TX packets: 68 errors: 0 dropped: 0 overruns: 0 carrier:0 collisions: 0 txqueueclcn: 1000 RX bytes: 0 (0.0 B) TX bytes: 3328 (3.2KiB) Link encap: Local Loopback inet addr:127.0.0.1 Mask: 255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets: 40 errors:0 dropped: 0 overruns:0 frame:0 TX packets: 40 errors: 0 dropped:0 overruns:0 carrier:0 collisions: 0 txquelen:0 RX Bytes: 3864 (3.7 KiB) TX bytes: 3864 (3.7 KiB) Link encap: UNSPEC HWAddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00 inet6 addr: fe80::1/28 Scope:Link UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:3 overruns:0 carrier:0 collisions:0 txquelen:0 RX bytes:0 (0.0B) TX bytes:0 (0.0B) Link encap: Ethernet HWaddr:00:24:8c:6e:bd:c0 inetaddr:192.168.1.5 Bcast:192.168.1.255 Mask: 255.255.255.0 inet6 addr: fe80::224:8cff:fe6e:bdc0/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:60 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txquelen:0 RX bytes(0.0B) TX Bytes:2776(2.7KiB)
My primary router is set up in this configuration:
Default Gateway: 96.253.86.1 DNS Server: 71.252.0.12 68.238.112.12
Although I have set the gateway and DNS server during installation to 192.168.1.1 for both, and the IP address as 192.168.1.5
Do I need to reinstall and use the default gateway as shown in my router? by the way, this is a cruddy MI424WR router. YUCK!
This is also as stated, hooked up directly to ethernet and appears to have a link.
I try to connect to 192.168.1.5 and it actually trys to connect for about a minute and then displays the typical "The connection has timed out" page. The server at 192.168.1.5(:8006)is taking too long to respond.
If it matters, I am also logged in as root while trying to connect.
