menormedia

Done troubleshooting.. I ended up factory resetting my pineapple and all is well.

Hmmm... well I'll try to install infusions on my 8GB card and see if the issue persists.

Thanks Spazi! :)

:( I still can't get it to run...

I tried using the "Revert Hosts" button but that didn't work either.

I've seen clients appear in this log with no issues. It shows all hosts connected to the Pineapple.

Would you happen to know what the default entries are for the hosts? :)

LOL I had to do it. You're very welcome. I'm interested in doing my own case also. I'll post a thread once I get the project started.

I didn't change the settings in the Index.php on the DNS Spoof page. I removed and reinstalled it. But it's still not working. Followed the same instructions.

I followed the instructions but it doesn't seem to work still.. I removed the entries in the spoofhost editor

Just Google "USB Amphenol", "Ethernet Amphenol", "DC Jack Amphenol", and so on.. You can also search on newark.com for these connectors.

I formatted it as ext4 but ended up just formatting it and leaving it unallocated. I put it in the Pineapple and it booted properly, then I formatted it from the GUI. Issue resolved. Thanks everyone!

What should the entries be set to on the Spoofhost Editor? Also, is there any other infusions that need to be enabled for the Roll infusion to work?

Just curious what is the battery in the Travel Kit rated at? How many mAH is it?

I know that but it stays like this indefinitely.. It seems like it's stuck somewhere..

I've got an 8GB micro sd that I want to format. I formatted it to ext4 but when I insert it into the pineapple i just get the blue flashing light.. What am I doing wrong here?

Awesome! I'm formatting my 8GB SD right now.

I installed infusions from the Bar onto the SD card. After a reboot I'm unable to use the infusions, I can see that they're installed but it shows 0 KB installed, nor are they showing up on the main screen. Should I have installed the infusions on the on-board memory?

Why is it that when I join a network on WLAN1 it disables and prevents me from making any changes via the GUI? The only way to recover from this is to run the following command in SSH (thanks to Seb): wifi detect > /etc/config/wireless && reboot

I'm interested in getting this working also. Is it possible to do this manually without using the Pineapple Bar? Like this

Yes. I got it going again :)

I'm getting a LED pattern from top to bottom (Red-Blue-Orange) at startup. Looking at the manual (page 9) it states that the "Firmware Flash completed successfully". I've left this on overnight and that's all it does.