Jump to content

HickorySwitch

Active Members
  • Posts

    3
  • Joined

  • Last visited

Recent Profile Visitors

163 profile views

HickorySwitch's Achievements

Newbie

Newbie (1/14)

  1. Ok. So i did what was suggested, and so far everything seems to be working great. Thanks for the help!! greatly appreciated. :)​
  2. Thank you for the quick response. I ran the script that follows: wget wifipineapple.com/wp4.sh; chmod +x wp4.sh; ./wp4.sh do i have to run this every time or do i only need to run this one once and then simply run ./wp4.sh from that point on?? I think i see from what you have both told me what I am doing wrong, I will give it a try and see how it goes. I've been connecting the wireless first and then the ethernet cable....I'll try the other way around.. Again thank you for your help.
  3. ifconfig: eth0 Link encap:Ethernet HWaddr e8:9a:8f:ed:6b:72 UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) Interrupt:43 Base address:0xc000 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:24 errors:0 dropped:0 overruns:0 frame:0 TX packets:24 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:1696 (1.6 KB) TX bytes:1696 (1.6 KB) wlan0 Link encap:Ethernet HWaddr e4:d5:3d:aa:93:06 inet addr:192.168.254.5 Bcast:192.168.254.255 Mask:255.255.255.0 inet6 addr: fe80::e6d5:3dff:feaa:9306/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:25741 errors:0 dropped:0 overruns:0 frame:0 TX packets:19328 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:34000830 (34.0 MB) TX bytes:2524833 (2.5 MB) iwconfig: lo no wireless extensions. eth0 no wireless extensions. wlan0 IEEE 802.11bgn ESSID:"WIN_530C" Mode:Managed Frequency:2.437 GHz Access Point: 4C:17:EB:18:53:0B Bit Rate=24 Mb/s Tx-Power=19 dBm Retry long limit:7 RTS thr:off Fragment thr:off Power Management:off Link Quality=47/70 Signal level=-63 dBm Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:1 Invalid misc:3252 Missed beacon:0 Acer Aspire one D257 Blackbuntu Wifi Pineapple Mark IV I just recently got my first wifi pineapple and tried to connect it to Backtrack 5 R3, but the only way i could get to the management page was if i was connected to the pineapple network, and i had no internet access (this is after leaving everyhing as default in the wp4.sh script) I tried it again in Ubuntu but had the same problem. However when i tried it in Blackbuntu I Ran the wp4.sh script, left everything default and it worked fine until i changed the password and rebooted the pineapple. The second time i tried it i had no problems at all. it worked great, but the third time i used it i started having the same issue as with Bactrack and Ubuntu. I could get to the managment page but i could not browse the internet on my laptop, or my client laptop. I am no doubt making a simple mistake in set up but i cant figure it out...... any suggestions??? thank you in advance for your help...
×
×
  • Create New...