traxsboy

Thanks think I need to up my Google fu

Just a heads up on serial flash bords you can use an arduno UNO board with the at mega chip removed connect pins one an zero to the rx and tx pins and gnd to well gnd and fire up putty and your off and when your done you can have ardiuno fun as well. mmm micro processor and pineapples

Im trying to set up two pineapples why would I set it up like this? Because I've had problems with mdk3 and karma. I think I'm askin too much out of the processor to spoof and karma had it set up with a 036nh the USB buckles and resets buggering up mdk3 Both are MK 4 and are both 2.7.0 and are set up like so: Internets | | Linux box running BT 5 R3 | | PoE port Pineapple one Running karma WAN/LAN | | PoE port Pineapple two Running mdk3 spoofing beacon frames I can ssh into pineapple one then when I try and ssh into pineapple two I end up back at one I've done all the forwarding on on the wan port on one Do I need to change the ip of pineapple two to ssh into it Thanks in advance

hi all first post here I've got a AP121U running on 2.0 took a bit of messing about but I'll post how i did it and you can see if and where i could of done it better I'm a noob at all of this so constructive help is welcome got my router from crucial wifi and used a ca-42 nokia cable to flash with putty on ubuntu 12.04 you have to add the serial to the dial up group set up a tftp fallowed the alfa instructions on how to flash the hornet board i got a kernel panic something over vs root sync rebooted it to option 2 then uploaded the upgrade.bin from the pineapple git hub reboot WIN!! it worked