Turbo-PS

I use this USB/Serial to flash chips for my 7.3 PSD. I just tried it agian and it is communicating with my programmer. At this point I would say MK4 or Alfa board are bad. I am willing to pay for and ship it all out if some one is wanting to verify one or both are bad or its me. Thanks.

Just cause, I went and dug up my old serial to usb adapter and tried it also on another pc. same thing. I power up the device and still do not see any communicatons.

Thank you for you help on this. I did hook up the console boad as illustrated in the wiki. Yes i gave the board power through the AD adapter and all my com ports settings were as the wiki. I did NOT flip the connector. I remove the TX/RX pins from the connector and reversed them. But I did not reverse the Power.

I am not able to see any communication. That is why i tried to swap the RX/TX cable and when that did not work I tried a Linux box.

Thank you for the response. I followed the Clean Flashing instructions and video on the wifipineapple.com site "The one in your Signature" . When that did not work I started to try some of the other suggestions on the hak5 forums. Since I am outside of my 90 days I may end up having to purchase another unit.

Hi, I guess this is what i Get for not testing this unit when I first got it "4 months ago". I finaly got around to try out my new MK4. When I power up the unit WPS LED will constant flash. I get nothing Wifi or wired and the reset button also did nothing. Power up seq with only power is plugged in. Power LED = on Lan LED = On for 2 seconds then goes Off, Then the WLAN LED turns on for 2 seconds then goes off. The LAN LED then turns on for 5 seconds then back off. After another 5= Seconds the WPS starts flashing. I went and ordered the Alfa Console Board and followed the set up instructions but I do not appear to be talking to the MK4. I did swap the TX/RX just to make sure and still nothing. I tired windows and linux just to be sure. Any help is greatly appreciated.

Thank you for the suggestions. I am going to try them and see what works best 'or I can get to work'.

DD-WRT Router, no wireless devices, 10 PC's with a mix of Windows XP and 7, Networked Printers and Security cameras that can do remote monitoring.

I am looking for a open source or free Network Bandwidth monitoring program for windows or linux. What I am trying to do is find out what devices on my network use what bandwidth. Any help is greatly appreciated.