DarkGreyTide

Does anyone have a wiring diagram for the Pineapple Juice 6800? Or just some pics will do. My unit wasn't charging and upon opening it up a couple of the wires had become detached. There is so much solder on the board I have no clue where they could go.

Awesome, thanks for the prompt help! You guys are great!

Terribly sorry about the spoiler tags, I couldn't quite find what to use. There is a boot loop without the sd card as well, that is the complete loop before the boot starts again. It looks like it may be a faulty PSU. I booted from the battery and was able to flash to the latest update. Out of curiosity i notice the red led is on on the power supply does that mean that it is having issues?

I see two different console outputs depending on whether I have the sd card inserted or not. I have attached both labeled appropriately. With sd card inserted. With no sd card inserted.

I booted my pineapple up and now I am getting a solid green and red light and the Ethernet interface is constantly cycling, I have had the unit since launch and have not had any issues with it up until this point. What I have done: Attempted a settings reset (10011) with the dip switches. Attempted a emergency unbricking (11110) I managed to get Stager installed however when I attempt to install the latest update 1.0.4 it never installs I just keep seeing the red and green light with maybe a couple of flashes of the amber and blue and the Ethernet interface is still cycling up and down. Opened up a console over ttl and found the unit is stuck in a constant boot cycle. It does not look like it ever makes it to the point of loading the update on the sd card (I also double checked the checksum and the .bin matches the md5 file). If needed I can post the console output I am seeing.