Arayanz

IOSYS, Thank so much....UT165 MP Tool 1.65.14.0 fixed my solution. Only issue that came up afterwards was that my laptop was not recognizing any USB drive... I did system restore and my 32GB A-Data Flash drive is back into business... Thanks again...

IOsys Hi, Thank so much for helping.... I tried following versions (all available) from flashboot.ru and found that problem is still there. Same symptoms even though each time FABULK showed up when flash is connected. I have tried UT163 / 3.9.8/3.9.12/3.9.29/3.9.31/3.9.35 Just listing above to make sure i am not missing anything. Btw, Following is the procedure i am folloiwng 1. Installing the MDPT tool 2. Connecting the flash (A-Data) and driver is installed and it is recognized as FABULK device 3. Starting MDPT tool and click on F1 Settings / Ut163 to change the partition (LUN0) to Auto and partition option checked. I did not change anything on the vendor data side and click OK 4. F3 (enumerate) and getting error "Number of Input devices is not matched with maximum device list!!!" I am ignoring this considering that my laptop has only three USB slots and min in the tool is 4 5. Port 1 shows the code:0x54 with 0Mb space and VID/PID as 0/0 6. Tried InfUpdate to make the VID/PID as showing in the settings options for MDPT but not change. Even though it unloads and loads the driver (FABULK) with this step. 7. If I press start, the code changes from 0x54 to 0x54/0xa2 Any thoughts? Thanks for your help

I am in same boat... Suddenly my 32GB A-Data USB got this USBest issue... I downloaded UT163 MPT tool(UT163 MPTool v3.9.35.0) and after installing the driver by MTP (FABULK), it read the USB as following Port1: Status:Code 0x54 Capacity 0MB USB VIP/PID = 0 <------------------------------ChipGenius reads it as 1307/0163 Write Protect = NO Operation Mode = Unknown ********************************CHIP GENIUS************* Device Name: +FABULK PnP Device ID: VID = 1307 PID = 0163 Serial Number: 5&&38C8E674&&0&&1 Revision: (Information not returned) Device Type: Standard USB device - USB2.0 High-Speed Chip Vendor: USBest(??) Chip Part-Number: UT163 Product Vendor: FABULK Product Model: ******************************************************** I realized from the Flashboot.ru that I can assign VID/PIV using C: \ Program Files \ MDPT \ Driver \ InfUpdate.ex but it does not change anything in the MPT tool after referesh. Parition is set to AUTO in the settings Tab. If I press start, i get Status Code : 0x54 0xa2 Please kindly help. I had given up on this USB but now there is some hope... Is that FABULK is not loaded correctly or am I using incorrect versoin of MPT tool... 0x54 means Firmware version mismatch with controller type. I see FABULK added into the list of drivers and also the light on my USB flashes with this driver installed.... Please help... Thanks in advance... Aray