LabRaTT Posted March 29, 2013 Share Posted March 29, 2013 I've been having issues getting my pineapple mark III to boot. So finally i hooked it up by the serial port and this is what outputs RedBoot(tm) bootstrap and debug environment [ROMRAM] Accton release, version v1.5.1 - built 20:10:40, Aug 19 2008 Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc. Board: ap51 RAM: 0x80000000-0x82000000, [0x8003f640-0x80fe1000] available FLASH: 0xa8000000 - 0xa87f0000, 128 blocks of 0x00010000 bytes each. == Executing boot script in 1.000 seconds - enter ^C to abort ^C RedBoot> fis list Name FLASH addr Mem addr Length Entry point RedBoot 0xA8000000 0xA8000000 0x00030000 0x00000000 rootfs 0xA8030000 0xA8030000 0x006B0000 0x00000000 vmlinux.bin.l7 0xA86E0000 0x80041000 0x00100000 0x80041000 FIS directory 0xA87E0000 0xA87E0000 0x0000F000 0x00000000 RedBoot config 0xA87EF000 0xA87EF000 0x00001000 0x00000000 RedBoot> reset +.. Resetting. Found AR8012 PHY ID is 004d:d021 at 1 Ethernet eth0: MAC address 00:c0:ca:32:88:b7 IP: 192.168.0.1/255.255.255.0, Gateway: 0.0.0.0 Default server: 0.0.0.0 RedBoot(tm) bootstrap and debug environment [ROMRAM] Accton release, version v1.5.1 - built 20:10:40, Aug 19 2008 Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc. Board: ap51 RAM: 0x80000000-0x82000000, [0x8003f640-0x80fe1000] available FLASH: 0xa8000000 - 0xa87f0000, 128 blocks of 0x00010000 bytes each. == Executing boot script in 1.000 seconds - enter ^C to abort RedBoot> fis load -d vmlinux.bin.l7 Image loaded from 0x80041000-0x80291086 RedBoot> exec Now booting linux kernel: Base address 0x80030000 Entry 0x80041000 Cmdline : Quote Link to comment Share on other sites More sharing options...
Mr-Protocol Posted March 29, 2013 Share Posted March 29, 2013 Try a re-flash using the Mark III method. Quote Link to comment Share on other sites More sharing options...
LabRaTT Posted March 30, 2013 Author Share Posted March 30, 2013 do you have a link? Quote Link to comment Share on other sites More sharing options...
Mr-Protocol Posted March 30, 2013 Share Posted March 30, 2013 To how to flash or the firmware? Flashing: Firmware: https://www.dropbox.com/sh/y0an70sofvtezzl/P1rMEo9R4a/Jasager/Mark%20III%20Firmware Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.