I already had a usb rubby ducky and thanks to the Kali-Linux install script of the Rubber Ducky Payload Generator this device now has a new attack vector granted I have access to a client station. Thanks Hak5!
I am now running kali linux on raspberry pi
I am now going to automate as much as i can
To use the setup I use a tablet and vnc into it
It takes about 3 minutes to power up everything, ssh into pi, startvnc and login
I hooked up the AWUS036NHA to the kali pi and did a real world wifi cracking test (wifite is built into kali)
I found a good spot with multiple networks and the signal strength isnt great, It took around 5 min
This whole getup is very easy to setup, I will actually be able to use this within 6 months on a clients network.
This is what it all looks like all parts cost around $350
Step 1 buy stuff: Buy raspberry pi, wifipineapple, 2 alfas, usb hub, 8gb usb drive, 16gb sdcard, ethernet cable
Step 2 setup pi: http://cdimage.kali....pberrypi.img.gz Dowload and write to sdcard put in pi thats it.
Step 3 setup pineapple: http://forums.hak5.o...rum/65-mark-iv/
Step 4 power them up: Plug the KaliPi into the pineapple poe jack. KaliPi automatically tries to connect on eth0,
Step 5 My pi is always assigned the address 172.16.42.157. SSH in to kalipi (pw:toor) install tightvncserver.
Step 6 Install raspi-config on Kali pi
git clone http://github.com/asb/raspi-config.git
I am a computer science student and just a nerd that likes to play with things
This is my first post. I recently got a raspberry pi and a wifi pineapple mark iv and set them up to work together. I just got a new battery pack (anker astro3 10000mAh) and it runs the two of them, it will run for close to 5 hours as pictured. I also use them with the Alfa AWUS036H (not pictured) and the AWUS036NHA. It took a little time but was not that hard. Raspberry pi instructions, Pwnpi and http://forums.hak5.o...rum/49-jasager/ I will update as the project gets better, for now...
With the raspberry pi you can make any tv or monitor your display with rca or hdmi. Or ssh and vnc into both devices from you laptop, tablet, or phone
I am working on complete automation based off the fact that Karma will bring devices to the network, and the pwnpi will attack most hosts on the pineapple network
Making it mobile, I thought about a pizza box but figured a solar backpack was a better bet
In this pic i am using the pineapple with the Alfa AWUS036H and AWUS036NHA.
I decided to use 2 power supplies: anker astro3 10000mAh to run the pineapple and an anker 8400mAh to run the pi
Edited by desarmy, 16 April 2013 - 07:06 PM.