Search the Community
Showing results for tags 'reset'.
Found 4 results
Hi, it is my first LAN Turtle, I ordered it as Bundle from the US Store. I did the Update to V2 with Putty & Network cable throug the LanTurtle I am not able to install anything from the Directory. I tryed factory Default reset with the .bin of your Website. Stil the same Problem. In the List of the Modules there is no X by Modulemange. When I select it, it tells me Current Status:Stopped And Bootup Status: Enabled When I go to configure I can select Modules from Directory but nothing is installed in the end. I tryed everthing! Is there a solution?
I have followed the wiki steps for factory resetting the Lan Turtle ( https://lanturtle.com/wiki/#!index.md ) In addition to this, I have followed this fellow who seems to have had the same problem. (And fixed it) However, I am having absolutely no luck reaching the internal webserver of the lan turtle. Once I type in 192.168.1.1 into my web browser, it hangs for approximately 2 seconds, and states that there is no internet. If someone could help me asap, it would be greatly appreciated, as I need it for a demonstration this week. (Tomorrow evening) Thank you for your time. PS. If it helps, I am on the Parrot operating system, although I do have both windows and default debian installed as well. (I've tried all 3 OSs, and still no luck.)
I am following these steps from the wiki: Factory Reset / "Unbricking" In the extreme case that a LAN Turtle has become permenantly inaccessible or inoperative, there is a quick method for recovery using a special web interface. Download the latest factory image from https://downloads.lanturtle.com/turtle-2-factory.bin Carefully open the LAN Turtle case by removing the two screws underneath the sticker on the bottom While holding the button on the bottom of the LAN Turtle, plug the device into a computer After 3 seconds let go of the button and wait an additional 30 seconds to receive an IP address from the LAN Turtle If you do not receive an IP address in the 192.168.x range from the LAN Turtle within a minute, statically assign the LAN Turtle's interface to 192.168.1.2 (netmask 255.255.255.0) Browse to the LAN Turtle firmware recovery web interface at http://192.168.1.1 Follow the on screen prompts to upload and flash the factory image downloaded in step 1 When the flash is complete the LAN Turtle will reboot and will be accessible again from 172.16.84.1 with the default username root and password sh3llz I do not get an IP in the 192.168.x.x range any time I hold down the button. When I hold down the button on my Kali linux box it comes up as 172.16.84.245 with a gateway of 172.16.84.1. If I manually set the adapter IP in Kali to 192.168.1.2 I am not able to get to a website using my web browser. I have tried this on a Linux Mint laptop, Kali linux laptop and Mac computer with all the same results. I have tried holding the button for 1 second and for 30 seconds and places in between with the same results. Do you think my LAN Turtle is defective?
SD card works sometimes, sometimes you need to remove it and put it back in order to make it work, also the recon get me " "No scan results." Even when i have 3 routers running next to me ( 2.4Gz) How do i fix that? I already did the factory reset 3 times!!