Ok, long and short - my Bunny won't run a payload...
I'm on firmware 1.3
I downloaded the repository from Git, extracted to Bunny.
The payload.txt in switch1 is
# System default payload
LED B SLOW
ATTACKMODE SERIAL STORAGE
I unplug the BB set switch to position 1, and plug it in; it shows Green for a couple of seconds then the LED shuts off and nothing...
And the BB never shows up as a Flash Drive.
BTW, in arming mode it does show up as a flash drive...
Any ideas?
Is there a way to do a factory reset of the BB?